PestControlLibrary
Menu
Active ingredient profile

Disodium octaborate tetrahydrate

Inorganic borate salt; IRAC Group 8D miscellaneous nonspecific (multi-site) inhibitors: borates.[1][2]

Disodium octaborate tetrahydrate is a water-soluble borate salt in IRAC Group 8D. Bora-Care, a 40% concentrate, is diluted and applied to bare wood to treat and prevent subterranean, Formosan and drywood termites, wood-boring beetles, carpenter ants and decay fungi.[1][2]

The label is the law. Read your product's label before you mix or apply; the rates here come from the labels listed under Sources.

Active ingredient
Disodium octaborate tetrahydrate (CAS 12280-03-4)
Chemical class
Inorganic borate salt; IRAC Group 8D miscellaneous nonspecific (multi-site) inhibitors: borates.[1][2]
Mode of action
IRAC Group 8D: Miscellaneous nonspecific (multi-site) inhibitors: borates[2]
Signal word
Bora-Care Termiticide, Insecticide and Fungicide Concentrate: Caution[1]

How long the treatment lasts

The label says treatment stays intact as long as the wood isn't exposed to rain, continuous water or direct ground contact. Wood touching soil has a limited lifespan and needs periodic retreatment.[1]

Insects that eat or infest treated wood contact the borate and die. Beetle larvae already inside may still emerge as adults afterward, but the label says reinfestation is prevented.[1]

Use with soil termiticides

Applied as a 1:1 mix, the label counts it as a primary pretreatment for subterranean termites in new construction. It can also back up a soil termiticide or bait system by protecting the wood itself.[1]

Where it is used

It only works on bare wood. Strip paint, stain or sealer first, because an intact water-repellent finish blocks the solution from soaking in.[1]

Wood exposed on only one or two sides, like sill plates on a foundation, gets two coats. Wait at least 20 minutes between coats.[1]

Keep treated exterior wood out of rain or snow for at least 48 hours. Then topcoat it with paint or exterior stain within 6 weeks.[1]

Don't spray it on soil, carpets or food-contact surfaces. Using it against bed bugs is prohibited.[1]

Products and registrations

ProductRegistrantEPA Reg. No.Active %FormulationSignal word
Bora-Care Termiticide, Insecticide and Fungicide Concentrate[1]Nisus Corporation64405-140.0%liquid concentrateCaution

Label rates

ProductUsePestsRate
Bora-Care Termiticide, Insecticide and Fungicide ConcentrateCrawl spaces, basements, sill plates, framing, logs and other bare structural woodSubterranean, Formosan and drywood termites; powderpost, anobiid and old house borer beetles; carpenter ants; brown and white rot fungi1 gallon diluted solution per 400 sq ft of surface[1]
Mix 1 part water to 1 part Bora-Care for subterranean termites and most remedial work, and 5 parts water to 1 for prevention against drywood termites and beetles. Wood floors take a 2:1 mix at about 1 gallon per 500 sq ft.

How to apply it, step by step

Steps for Bora-Care Termiticide, Insecticide and Fungicide Concentrate (40% disodium octaborate tetrahydrate), EPA Reg. No. 64405-1, taken from its label[1]. Other products with this active ingredient have their own labels; follow yours.

1. Protective gear

  • Wear a long-sleeved shirt, long pants, socks, shoes, protective eyewear and chemical-resistant gloves (such as nitrile, butyl or neoprene rubber or PVC); it is harmful if absorbed through the skin.[1]

2. Before you spray

  • It is a wood treatment for termites, wood-boring beetles, carpenter ants and wood-decay fungi in structures; it is prohibited for bed bugs, on carpets, directly on soil, and on food-contact surfaces.[1]
  • Apply it only to bare wood and surfaces: paint, stain or sealer blocks it. Nobody else should be in the area during application.[1]
  • When spraying overhead indoors, cover everything below with plastic sheeting; remove pets and turn off and cover aquarium pumps.[1]
  • It is toxic to fish and wildlife: keep it out of water and don't dump rinse water where it can reach water.[1]

3. Mixing

  • Mix the thick concentrate with water by volume (warm water helps; a drill-mounted mixer speeds it up): 1 part water to 1 part Bora-Care for subterranean termites and most remedial work, 2:1 for some uses such as wood floors, and 5:1 for prevention against drywood termites and beetles.[1]
  • Use 1:1, 2:1 and 3:1 mixes within 24 hours; a 5:1 mix keeps up to 30 days. Don't leave mix in a pressurized tank overnight.[1]

4. Applying

  • In crawl spaces and basements, apply one coat to all accessible wood (sill plates, piers, girders, subfloors, joists); wood exposed on only one or two sides gets two coats, at least 20 minutes apart. A gallon of mix covers up to 400 sq ft.[1]
  • To keep subterranean termites from building shelter tubes, apply the 1:1 mix to the interior foundation walls 2 feet up from the ground.[1]
  • Where an infestation can't be reached from the surface, drill small holes and inject enough mix to flood the galleries; treat adjacent sound wood through holes every 8 to 10 inches.[1]

5. After you spray

  • Don't let anyone into treated areas until the spray has soaked into the wood.[1]
  • Rinse equipment and lines with water after use.[1]

First aid

  • On skin or clothing, take off contaminated clothing and rinse right away with plenty of water for 15 to 20 minutes; in the eyes, rinse gently for 15 to 20 minutes, removing contact lenses after the first 5; then call a poison control center or doctor.[1]

Storage, spills and disposal

  • Store it in its original container, preferably locked, out of reach of children and pets, and don't let it freeze.[1]
  • Don't reuse the empty container; call your local solid waste agency for disposal instructions, and never put product down a drain.[1]

From the safety data sheet

From the product's safety data sheet[3]. Where it and the label differ, the label is the law.

  • Besides 40% disodium octaborate tetrahydrate, the concentrate is 40-60% ethylene glycol; the SDS classifies it as harmful if swallowed, may damage fertility or the unborn child, and may damage organs through prolonged or repeated exposure (signal word Warning).[3]
  • It is a clear, viscous gel with a flash point above 220 °F.[3]
  • Keep containers closed when not in use, store in a cool, dry, well-ventilated area, locked up and out of reach of children, and protect containers from physical damage; don't reuse empty containers.[3]
  • Dike or soak up spills with an inert absorbent, put the waste in containers for disposal, and keep spills out of sewers and watercourses.[3]

Need the amount for your sprayer? Use the mixing calculator, which works from the same label rates.

Safety and environmental hazards

People

Signal word CAUTION: harmful if absorbed through skin. Handlers wear long sleeves, long pants, socks, shoes, protective eyewear and chemical-resistant gloves. Nobody occupies treated areas until the spray has soaked into the wood.[1]

Pets

Before spraying overhead inside a home, remove all pets, turn off fish aquarium pumps and cover the tanks. Cover surfaces below with plastic sheeting.[1]

Bees and pollinators

The label has no bee warning. It does warn the product may injure plants, so cover shrubs near exterior work.[1]

Fish and water

Toxic to fish and wildlife. Don't apply it directly to water or contaminate water when cleaning equipment.[1]

Common questions

How do you mix Bora-Care?
Dilute it with clean water by volume: 1:1 for subterranean termites and remedial treatment, and 5:1 for prevention. Use 1:1, 2:1 and 3:1 mixes within 24 hours; a 5:1 mix keeps up to 30 days.[1]
How much area does a gallon of Bora-Care cover?
One gallon of diluted solution treats up to 400 square feet of surface, such as subfloor, joists and sill plates in a crawl space.[1]
Can Bora-Care go on painted wood or decks?
Only after the paint or finish is removed. Decks, sheds and fences need bare wood, then a water-resistant topcoat within 6 weeks.[1]

Sources

  1. U.S. EPA Pesticide Product Label System, “Bora-Care Termiticide, Insecticide and Fungicide Concentrate label, EPA Reg. No. 64405-1 (EPA-stamped, Sept. 24, 2025).” www3.epa.gov/pesticides/chem_search/ppls/064405-00001-20250924.pdf (accessed 2026-10-06)
  2. Insecticide Resistance Action Committee, “IRAC Mode of Action Classification Scheme, Version 11.5 (Feb. 2026).” irac-online.org/documents/moa-classification/ (accessed 2026-10-06)
  3. Nisus Corporation, “Bora-Care Safety Data Sheet (Nisus Corporation, SDS NIS-008, revision dated October 19, 2022; copy hosted by Dodson Bros.).” labeling.dodsonbros.com/labeling/Live/Bora-Care/sds/Bora-Care%20SDS%2010-19-2022.pdf (accessed 2026-10-15)

Updated 2026-10-15. Built from sourced records; every rate traces to a product label. Spot an error? Tell us.