The label is the law. Read your product's label before you mix or apply; the rates here come from the labels listed under Sources.
- Active ingredient
- Nithiazine
- Chemical class
- The label names it 2H-1,3-thiazine, tetrahydro-2-(nitromethylene), carried in a yellow sugar-based bait matrix.[1]
- Mode of action
- Fly bait that kills through ingestion, as the label describes it; nithiazine is not listed in the IRAC classification[1]
- Signal word
- Starbar QuikStrike Fly Abatement Strip (Sandoz 9023 Fly Bait Station): Caution[1]
Made for the dumpster, the barn and the loading dock
Placement examples on the label include garbage chutes, waste containers, grease pits, outdoor restrooms, stables, dairy barns, milking parlors, kennels, aviaries, swine houses and areas around restaurants and groceries.[1]
The label says a single application kills flies for up to 8 weeks and attracts them within a 300-square-foot area. Ventilation doesn't reduce its effect because flies have to feed on it.[1]
Where it is used
Keep strips low, no higher than 4 feet. The label explains that flies feed near the ground, while flies seen higher up are mostly resting.[1]
Fix the strip firmly to a stationary surface with adhesive, since flies won't land on something swinging in the wind. Flat surfaces work best.[1]
At setup, squeeze the attractant ampoule until it snaps. Don't crush it, and expect a strong odor.[1]
Shield strips from moisture and direct sun where you can, and skip spots that get wet every day. Replace the strip when it stops working well.[1]
Products and registrations
| Product | Registrant | EPA Reg. No. | Active % | Formulation | Signal word |
|---|---|---|---|---|---|
| Starbar QuikStrike Fly Abatement Strip (Sandoz 9023 Fly Bait Station)[1] | Wellmark International | 2724-461 | 1.0% | fly bait strip with attractant ampoule | Caution |
Label rates
| Product | Use | Pests | Rate |
|---|---|---|---|
| Starbar QuikStrike Fly Abatement Strip (Sandoz 9023 Fly Bait Station) | Dumpsters, garbage chutes, loading docks, barns, kennels, poultry houses, feedlots, restaurants and other fly-problem sites | House flies and lesser house flies | 1–3 strips per 300 sq ft[1] Use 1 strip per 300 sq ft in enclosed sites with low to moderate fly numbers. Open structures or heavy fly pressure call for 1 strip per 100 to 150 sq ft. |
How to apply it, step by step
1. Protective gear
- The strip carries the CAUTION signal word, and its one hazard statement is to keep it out of your eyes. Handle each strip by its curved ends.[1]
2. Before you spray
- The label says the strips work best against house flies and lesser house flies, and gives placement examples such as dumpsters, garbage chutes, loading docks, outdoor restrooms, stables, dairy barns, kennels, poultry houses and aviaries.[1]
- Work out how many you need: 1 strip per 300 sq ft in enclosed structures with low to moderate fly numbers, or 1 per 100 to 150 sq ft in open structures or where flies are heavy.[1]
- Pick spots out of reach of children and animals that stay dry and, where possible, out of direct sun. Too much moisture shortens how long a strip lasts, so avoid places that get wet from daily activity.[1]
3. Mixing
- There's nothing to mix. Take the strip out of its protective pouch and, when you put it up, squeeze the attractant ampoule tube until you hear it snap. The attractant has a strong odor.[1]
4. Applying
- Mount the strip close to the ground near where flies feed, and no higher than 4 feet: flies seen higher up are mostly resting rather than looking for food.[1]
- Fasten it to something that doesn't move, such as a wall, fence, pole, feed bunk, refuse bin or dumpster, with an adhesive that will hold it for the life of the strip. It works at any angle but best on a flat surface, and flies won't land on a strip that swings in the wind.[1]
5. After you spray
- Flies that feed on the yellow sugar bait die shortly afterwards, and ventilation doesn't reduce the effect because it works through feeding. Where flies are only light to moderate, control can be less obvious.[1]
- Replace the strip when it stops working well.[1]
First aid
- If it gets in someone's eyes, hold them open and rinse slowly and gently with water for 15 to 20 minutes, taking out contact lenses after the first 5 minutes, then call a poison control center or doctor for treatment advice. Have the container or label with you.[1]
Storage, spills and disposal
- Store strips in a cool, dry place away from children and animals. To throw one away, wrap it in newspaper and put it in the trash.[1]
From the safety data sheet
- Wellmark's safety data sheet uses the GHS signal word Danger, while the EPA label uses CAUTION. It classes the product as a combustible liquid that causes severe skin burns and serious eye damage and may cause an allergic skin reaction, and its health-effects notes tie those hazards to the attractant ampoule.[2]
- The sheet lists the ampoule's ingredients as (Z)-9-tricosene (22.3%), butyric acid (33.3%) and trimethylamine hydrochloride (33.4%), and the strip's as nithiazine (1%) with corn starch and sucrose.[2]
- In rat tests nithiazine had an oral LD50 of 285 to 314 mg/kg and a dermal LD50 above 2,000 mg/kg, while (Z)-9-tricosene's oral LD50 was above 5,000 mg/kg. The sheet says nithiazine tested negative for mutagenicity and does not cause birth defects.[2]
- If ampoule liquid gets on skin, take off contaminated clothing right away and wash with plenty of soap and water, getting medical advice if irritation or a rash develops. For the eyes, rinse cautiously with water for several minutes, removing contact lenses if that's easy; the sheet's precautionary statements also say to call a poison center or doctor immediately.[2]
Safety and environmental hazards
People
Signal word CAUTION: avoid contact with eyes. If it gets in an eye, hold it open and rinse gently with water for 15 to 20 minutes, then call a poison control center or doctor.[1]
Pets
Hang or attach strips where children and animals can't reach them, and store unused strips away from both in a cool, dry place.[1]
Bees and pollinators
The label has no bee statement. The bait works only when insects eat it from the strip.[1]
Fish and water
The label has no aquatic hazard statement. Used strips are wrapped in newspaper and put in the trash.[1]
Common questions
- How many QuikStrike strips do I need?
- One per 300 square feet in enclosed spaces with light to moderate flies, or one per 100 to 150 square feet in open buildings or heavy infestations.[1]
- Which flies does it work on?
- The label says it is most effective against the house fly and the lesser house fly.[1]
- Why isn't my fly strip working?
- The label warns that strips hung above 4 feet, strips that move in the wind, and strips that stay wet all lose effectiveness. With light infestations, control may also be less obvious.[1]
Sources
- U.S. EPA Pesticide Product Label System, “Sandoz 9023 Fly Bait Station (Starbar QuikStrike Fly Abatement Strip) label, EPA Reg. No. 2724-461 (EPA-stamped, Feb. 26, 2009).” www3.epa.gov/pesticides/chem_search/ppls/002724-00461-20090226.pdf (accessed 2026-11-08)
- Wellmark International (copy hosted by DoMyOwn), “Starbar QuikStrike Fly Abatement Strip Safety Data Sheet (Wellmark International, issued April 11, 2016, revised September 28, 2018, version 1.0; EPA Reg. No. 2724-461).” domyown.com/msds/QuikStrike_Fly_Abatement_Strip_SDS_2020.pdf (accessed 2026-11-08)