The label is the law. Read your product's label before you mix or apply; the rates here come from the labels listed under Sources.
- Active ingredient
- Transfluthrin
- Chemical class
- Pyrethroid; IRAC lists transfluthrin in Group 3A sodium channel modulators.[2]
- Mode of action
- IRAC Group 3A: Sodium channel modulators: pyrethrins and pyrethroids[2]
- Signal word
- Dynatrap Mosquito Repellent (device with 16-hour or 48-hour refill cartridges): Caution[1]
Outdoors and semi-enclosed spaces only
The label allows use outdoors and in semi-enclosed areas such as porches, gazebos, garages and canopied areas. It rules out indoor use and enclosed spaces, naming tents as an example.[1]
Keep the device out of rain and standing water, and store it indoors when you're not using it. Let it cool for 5 minutes and recap the cartridge before you bring it in.[1]
Where it is used
Charge the device fully before first use. Uncap a refill, push it up into the bottom until it clicks, and press the power button.[1]
Give it up to 15 minutes to build the protection zone. On a windy evening, put the device upwind of where you're sitting.[1]
If mosquitoes still bother you after 15 minutes, check that the light is on, the cartridge still has liquid, the wick is intact, and you are within 14 feet of the device.[1]
Swap the cartridge when the liquid level runs low. Refills come in 16-hour and 48-hour sizes; put the cap back on whenever a refill is out of the device.[1]
Products and registrations
| Product | Registrant | EPA Reg. No. | Active % | Formulation | Signal word |
|---|---|---|---|---|---|
| Dynatrap Mosquito Repellent (device with 16-hour or 48-hour refill cartridges)[1] | Woodstream Corporation | 36488-72 | 8.83% | liquid refill cartridge in a heated, fan-driven device | Caution |
Label rates
| Product | Use | Pests | Rate |
|---|---|---|---|
| Dynatrap Mosquito Repellent (device with 16-hour or 48-hour refill cartridges) | Yards, patios, decks, porches, gazebos, garages and canopied areas | Mosquitoes | 1 device per 616 sq ft zone (14 ft radius)[1] Set the device in the middle of the space you want covered, on a flat surface about 30 inches off the ground. To protect a bigger area, the label suggests spacing extra devices 28 feet apart. |
How to apply it, step by step
1. Protective gear
- No gear is needed, but the liquid is harmful if inhaled and may irritate eyes: avoid getting it on your skin or clothing, and wash with soap and water after handling a cartridge.[1]
2. Before you spray
- Use it only outdoors or in semi-enclosed spaces such as porches, decks, gazebos, garages and canopied areas, never indoors or in tents.[1]
- Charge the device first, and use only Dynatrap refill cartridges in it.[1]
- It is toxic to fish and bees: don't use it on or near water.[1]
3. Mixing
- No mixing: unscrew the cartridge cap (keep it), and push the cartridge up into the bottom of the device until it clicks, with the wick unobstructed.[1]
4. Applying
- Set it in the middle of the area you want protected, on a level surface about 30 inches off the ground with the vents clear; if it's windy, put it upwind of where you're sitting.[1]
- Press the power button; it takes up to 15 minutes to build protection across a 28-foot-wide zone (about 616 sq ft).[1]
5. After you spray
- Turn it off when you're done and recap the cartridge for storage; replace the cartridge when you can no longer see liquid through it.[1]
- Keep the device out of rain and standing water, and wipe dirt or condensation off with a damp towel.[1]
First aid
- If inhaled, move the person to fresh air and call 911 if they aren't breathing; in the eyes or on skin, rinse with water for 15 to 20 minutes and call a poison control center or doctor.[1]
- If swallowed, call a poison control center or doctor right away; don't induce vomiting and don't give the person any liquid, because it contains petroleum distillate.[1]
Storage, spills and disposal
- Store cartridges tightly capped in a cool, dry place children and pets can't reach, away from temperature extremes; store the battery device away from heat or flame.[1]
- Don't reuse, puncture or burn empty cartridges: put them in the trash or recycling; for a partly full one, call your local solid waste agency, and never pour it down a drain.[1]
Safety and environmental hazards
People
Signal word CAUTION: harmful if inhaled and may cause eye irritation. Avoid contact with skin, eyes or clothing, and wash with soap and water after handling. If it's swallowed, call a poison control center or doctor at once and don't induce vomiting unless told to; the refill contains petroleum distillate.[1]
Pets
Store the device and refills where children and pets can't reach them. The label gives no pet-specific directions beyond that.[1]
Bees and pollinators
The environmental hazards statement says the product is toxic to bees.[1]
Fish and water
Toxic to freshwater fish and invertebrates. Don't apply it to water, and never pour unused product down an indoor or outdoor drain.[1]
Common questions
- How big an area does one Dynatrap Mosquito Repellent cover?
- A zone about 28 feet across, or 616 square feet, when the device sits in the middle of the area.[1]
- Can I use it inside a tent?
- No. The label excludes enclosed spaces such as tents and says not to use it indoors.[1]
- Is transfluthrin safe for bees and fish?
- The label says it is toxic to bees and to freshwater fish and invertebrates, and tells you not to apply it to water.[1]
Sources
- U.S. EPA Pesticide Product Label System, “Dynatrap Mosquito Repellent label, EPA Reg. No. 36488-72 (EPA-stamped, Mar. 27, 2026).” www3.epa.gov/pesticides/chem_search/ppls/036488-00072-20260327.pdf (accessed 2026-10-06)
- Insecticide Resistance Action Committee, “IRAC Mode of Action Classification Scheme, Version 11.5 (Feb. 2026).” irac-online.org/documents/moa-classification/ (accessed 2026-10-06)