PestControlLibrary
Menu
Active ingredient profile

Potassium phosphite

Phosphonate; FRAC Group P07, the host plant defense inducers, a group FRAC moved to P07 from its former code 33 in 2018.[2]

Potassium phosphite products contain mono- and di-potassium salts of phosphorous acid, a FRAC Group P07 phosphonate that FRAC rates as low resistance risk. Agri-Fos Systemic Fungicide has a residential sub-label for home gardens, lawns and ornamentals.[1][2]

The label is the law. Read your product's label before you mix or apply; the rates here come from the labels listed under Sources.

Active ingredient
Mono- and di-potassium salts of phosphorous acid (potassium phosphite)
Chemical class
Phosphonate; FRAC Group P07, the host plant defense inducers, a group FRAC moved to P07 from its former code 33 in 2018.[2]
Mode of action
FRAC Group P07: Host plant defence induction: phosphonates (phosphorous acid and salts)[2]
Signal word
Agri-Fos Systemic Fungicide (residential sub-label; also registered as Agri-Fos 400): Caution[1]

Measuring small amounts

The label's conversion table helps with small batches. One-third fluid ounce equals 2 teaspoons, half an ounce is 3 teaspoons, and 1 fluid ounce is 2 tablespoons or 6 teaspoons.[1]

Indoor plants

When treating houseplants, don't overspray and keep it on the target plants. If you can't, move the plants outdoors to spray and dry before bringing them back in.[1]

Where it is used

Before treating a plant species for the first time, spray a few plants, wait 3 days, and check for leaf burn.[1]

Fill the sprayer a quarter to half full of water, add the product slowly while mixing, then top it off. Keep agitating while you spray.[1]

Apply before disease develops. Don't treat plants that are heat or moisture stressed or dormant, and never spray at intervals shorter than the label allows.[1]

Besides foliar sprays, the label allows soil drenches, mixing into potting media, basal bark sprays and bare-root dips, each at its own rate.[1]

Products and registrations

ProductRegistrantEPA Reg. No.Active %FormulationSignal word
Agri-Fos Systemic Fungicide (residential sub-label; also registered as Agri-Fos 400)[1]Liquid Fertiliser Pty. Ltd. (trading as Agrichem)71962-145.8%liquid concentrateCaution

Label rates

ProductUsePestsRate
Agri-Fos Systemic Fungicide (residential sub-label; also registered as Agri-Fos 400)Home ornamentals such as azaleas, rhododendrons, roses, boxwood, hibiscus and indoor foliage plantsDowny mildew, powdery mildew, bacterial blight, Phytophthora root rot, black spot2–4 tsp product per gallon of water[1]
Wet all foliage. Bacterial blight sprays repeat every 7 to 14 days; downy and powdery mildew sprays repeat every 14 days. Powdery mildew and black spot uses are not for California.
Agri-Fos Systemic Fungicide (residential sub-label; also registered as Agri-Fos 400)Home lawnsPythium; Rhizoctonia; suppression of anthracnose5–10 fl oz product per 1,000 sq ft[1]
For Pythium, mix in 1 to 5 gallons of water and repeat every 14 to 21 days. For Rhizoctonia and anthracnose, use 2 gallons of water every 7 to 14 days. Those two uses are not for California.

How to apply it, step by step

Steps for Agri-Fos Systemic Fungicide (45.8% mono- and di-potassium salts of phosphorous acid), residential sublabel, EPA Reg. No. 71962-1, taken from its label[1]. Other products with this active ingredient have their own labels; follow yours.

1. Protective gear

  • The label lists no specific gear: it is harmful if swallowed, inhaled or absorbed through the skin and causes moderate eye irritation, so avoid breathing the mist, keep it off your skin and clothing, and wash with soap and water afterward.[1]

2. Before you spray

  • It is a systemic fungicide for home gardens, lawns and ornamentals, applied as a leaf spray, soil drench, root dip or bark spray against diseases such as Phytophthora and Pythium root rots, downy mildew and bacterial blight.[1]
  • The first time you use it on a kind of plant, spray just a few, wait 3 days, and check for leaf burn before treating the rest.[1]
  • Spray in calm weather when no rain is forecast for 24 hours, and keep it out of drains and gutters.[1]

3. Mixing

  • Fill the sprayer ¼ to ½ full of water, add the product slowly while mixing, then add the rest of the water; keep it agitated while you spray.[1]
  • The label's conversions: 1 fl oz = 2 tablespoons = 6 teaspoons; ½ fl oz = 3 teaspoons.[1]
  • Rates depend on the plant and disease: on home ornamentals such as azaleas, rhododendrons, roses and boxwood, 2 to 4 teaspoons per gallon; on lawns, 5 to 10 fl oz per 1,000 sq ft.[1]

4. Applying

  • For leaf sprays, use enough water to cover the foliage and spray to wetness without runoff.[1]
  • For prevention, use the lower rate every 2 to 4 weeks once plants are established; to control an active disease, use the higher rate every 2 to 3 weeks until it is under control.[1]
  • Never apply it more often than every 3 days.[1]

5. After you spray

  • On food plants, harvest only after the spray has dried.[1]
  • Rinse the sprayer over the treated area so rinse water doesn't run into drains.[1]

First aid

  • If swallowed, call a poison control center or doctor right away, have the person sip water if they can swallow, and don't induce vomiting unless told to.[1]
  • In the eyes or on skin, rinse with water for 15 to 20 minutes (remove contact lenses after 5 minutes, take off contaminated clothing); if inhaled, move the person to fresh air. The label lists National Poison Control, 1-800-222-1222.[1]

Storage, spills and disposal

  • Store it upright with its original cap, away from heat and strong oxidizers; if you ever move it to another container, use a clean, suitable, clearly labeled one.[1]
  • Keep it away from water, food and feed in storage, and never pour it down a drain.[1]

Need the amount for your sprayer? Use the mixing calculator, which works from the same label rates.

Safety and environmental hazards

People

Signal word CAUTION: harmful if swallowed, absorbed through skin or inhaled, and it causes moderate eye irritation. Avoid breathing spray mist and wash with soap and water after handling.[1]

Pets

The hazard statement covers people and domestic animals alike. On lawns, the label says not to irrigate or mow until the spray has completely dried.[1]

Bees and pollinators

The residential label has no bee or pollinator statement.[1]

Fish and water

Keep it out of storm drains, ditches, gutters and surface water. Spray in calm weather with no rain forecast for 24 hours so it isn't blown or washed off the treated area.[1]

Common questions

Is potassium phosphite the same as phosphorous acid?
The active ingredient is the mono- and di-potassium salts of phosphorous acid. Each gallon of Agri-Fos holds 5.17 lb of the salts, equal to 3.35 lb of phosphorous acid.[1]
How much Agri-Fos per gallon for roses and shrubs?
2 to 4 teaspoons per gallon of water as a foliar spray for most listed ornamental diseases.[1]
Will diseases become resistant to phosphite?
FRAC lists the phosphonates, including phosphorous acid and its salts, as low resistance risk.[2]

Sources

  1. U.S. EPA Pesticide Product Label System, “Agri-Fos Systemic Fungicide label, EPA Reg. No. 71962-1 (EPA-stamped, Dec. 18, 2020).” www3.epa.gov/pesticides/chem_search/ppls/071962-00001-20201218.pdf (accessed 2026-10-06)
  2. Fungicide Resistance Action Committee, “FRAC Code List 2025.” www.frac.info/media/ljsi3qrv/frac-code-list-2025.pdf (accessed 2026-10-06)

Updated 2026-10-15. Built from sourced records; every rate traces to a product label. Spot an error? Tell us.